CompTIA Network+ Question C-65

A network technician receives a spool of Cat 6a cable and is asked to build several cables for a new set of Ethernet runs between devices. Which of the following tools are MOST likely needed to complete the task? (Choose three.)

A. Wire stripper
B. Cable crimper
C. RJ-11 connectors
D. RJ-45 connectors
E. Multimeter
F. Punchdown tool
G. Tone generator

Correct Answer: ABD

CompTIA A+ 220-902 Question J-39

A new user reports that they are unable to login to the corporate network on their desktop but they are able to access the WLAN from their mobile device. After further inspection, the technician realizes that the wall port is not wired correctly. Which of the following tools would be used to permanently restore network connectivity to the desktop?

A. Wireless locator
B. Tethering with mobile device
C. Punchdown tool
D. Crimper

Correct Answer: C

CompTIA A+ Question I-77

After making a long CAT5 cable, the technician fears that the cable may have been damaged during the pull, but does not have a cable tester. Which of the following would be the BEST alternative tool to determine whether there are any breaks or shorts in the cable?

A. Multimeter
B. Voltmeter
C. Loopback plug
D. Punchdown tool

Correct Answer: A

CompTIA A+ Question H-44

Peter, a technician, is tasked to install a new client machine. He notices the machine is not getting any network connectivity. He tests the network cable between the PC and the network jack and confirms it is good. Peter goes to the network closet and finds several network cables not connected to the switch. Which of the following tools would Peter use to determine which cable goes back to the correct network jack?

A. Loopback plug
B. Toner probe
C. WiFi analyzer
D. Punchdown tool

Correct Answer: B

CompTIA A+ Question D-2

A technician is asked to repair a broken Ethernet jack in a conference room. Which of the following tools would the technician use when repairing the wall jack?

A. Crimper
B. Toner probe
C. Punchdown tool
D. Multimeter

Correct Answer: C

CompTIA A+ Question C-99

A network technician is in charge of creating the network cut sheet for an existing building. Some of the ports have been labeled, but some of the labels are unreadable. Which of the following tools would be BEST used to identify termination location?

A. Tone generator and probe
B. Loopback plug
C. Cable tester and certifier
D. Punchdown tool

Correct Answer: A